ASPIRADOR DE HUMO EVO 2.1 RE – 230V + BRAZO 3m

Filter replacement varies according to the use and frequency of use of the machine.
The clogging/build up of dirt on the filters may vary according to :
• Welding material (every material generates different fumes/powder)
• Welding type (each process such as MIG, TIG, electrode, etc….)
• Elements in contact (for example oil, grease, paint, etc. which generate more «agressive» fumes).A
To replace the filters, a triangle key (FIG II) is necessary. This key is supplied with the machine, which opens the filters’ inspection panels.
Opening that panel allows direct access to the filter section. Removing the filters is done by pulling them one by one towards the outside.
Note that the filtering section may be difficult to remove due to the seals which are set up around the filters. These hermetic seals (which are pressurised) guarantee the optimal filtering of the extracted particules.
Removing the filters must be done in the following order, starting with the lowest filter; which has a frame that can be used as a bearing point